Sponsored Links


September 2007
« Aug   Oct »

Drywall Patching - Repairing Old Walls

Most beginning remodeling projects usually involve removing walls and building new ones. There areas that need patching. Below are some of the more common details.
The upper left of this photo shows where we removed a wall. I mentioned before about using your utility knife to cut into the corners where you are removing walls, to minimize the repairs necessary. If you look at the upper left, I deliberately did not cut the corner on the left corner for about a foot, and you can see the tearout that results. This area will need skimming at some point, and is extra work.
Ceiling area where old wall was removed

Patching these is a simple process with small rips of drywall. (Note: depending on your area, most often your interior walls have 1/2” drywall. Exterior walls and ceilings in most parts of the country have 5/8” drywall. You will want to check.)
Also see how much cleaner the repair area is when you cut into the corners before demolition. This job has texture on the walls that will be matched later. I use mesh tape for these flat areas and paper tape for inside corners.
Because this is a relatively narrow area, using an 8” knife will allow you to mud all your tape at one time.
Here is a detail showing drywall patching on a wall.

Here is a wall section with the patches applied and taped. The left side of this photo shows a tapeless patch, that we added because of moving an outlet and needing access for the romex run. I also ran paper tape to reestablish the inside corner.
Here is a tapeless drywall patch on a wall .

This is where the old closet header was attached to the wall. I used a ‘tapeless’ patch here.

Comments are closed.