Sponsored Links

Archives

April 2011
M T W T F S S
« Mar   Mar »
 123
45678910
11121314151617
18192021222324
252627282930  

Textured Drywall Patch

A recent job had me checking the plumbing on a house being freshened up. After replacing the mixing valve in one bathroom I came to find out that the previous owner had never used the shower, which filled the valve body with crap requiring replacement. This of course after the walls had been painted and carpet laid. Since the shower was tiled. entry from the front was a non starter.

After measuring the walls, I got lucky and discovered that the common wall was in a closet. In order for the plumber to get in, I needed to cut him a hole. Because the walls were textured, I needed to minimize the damage, so I cut the access with a utility knife. This takes longer than with a keyhole saw or a router, but the walls have been painted and new carpet installed.

I bagged and taped off the floor and cut the hole.

Here is the hole.  The studs were already in place. Yeah the plumber got his work done in that little hole. He is that good.

Next up is re-installing the drywall.  Because of  the backing screwing it back in was a breeze. Looking at the bottom of this photo you can see where I taped off the trim and taped it to the poly on the floor.

I used my old friend mesh tape for covering the seams. Here I have taped the horizontal and vertical wall seams. If you look closely you can see the tape line where somebody else  had opened this wall before to work on the drain.

Tech Tip: When you tape or repair drywall always do the butt joints first, cover the ends of the butt joints with the flats, (factory recessed seams) and finally the corners allowing you to overlap the ends with your corner tape. It makes taping easier as you will not telegraph the seams requiring more sanding to finish.

Here is the final tape. Notice the corner tape extends beyond the flat. This helps with finishing.

Next is the mud. Here your coats need to be thin enough to just cover without creating large bulges that are more work.

Because this is a ‘knock down’ texture After the mud is dry and you have sanded it lightly, texture in a can is applied. Follow the directions on the can as far as testing it on cardboard and following the directions in terms of drying time before ‘knocking it down’.

After this dries, before you repaint, lightly sand the area to match the original finish. You want to round the edges to hide your repair especially if your wall has been painted many times. I took the time to cover and texture the previous repair since I was in the neighborhood.

All done! the photo sucks but nobody who has looked at it can find it. And that is name of the game.